阳平关砂金矿精选厂尾矿综合回收的研究

本文详细的介绍了陕西省阳平关砂金矿精选厂尾矿金和其他可利用的矿物综合回收方法和最佳分选流程。     

The Continuous Interpolating Self-organizing Map

The self-organizing map (SOM) [5] provides a general data approximation method which is suitable for several application domains. The topology preservation is an important feature in data-analysis and may also be advantageous for the evaluation of the data in a function approximation or regression task. For this reason the interpolated self-organizing map (I-SOM) adds an output layer to the SOM architecture which computes a real valued output vector. This paper presents an extension of I-SOM towards a continuous interpolation. It is compared to RBF and to the parametrized self-organizing map.     

Electrochemical Aspects of Electroosmotic Dewatering of Clay Suspensions

An attempt is made to elucidate the electrochemical aspects of the electroosmotic dewatering (EOD) of clays as reported in some recent work, especially that on interrupted DC power electroosmotic dewatering published by Rabie, Mujumdar and Weber (2). These authors showed that the dewatering by EOD stops after the DC power has been on for several minutes or hours; on interruption of their power and on short-circuiting of the electrodes, conditions can be created again for some further dewatering by DC power EOD. This discovery, of Rabie et al. is interpreted as a fuel cell effect and it is shown that it affords clues to several other electrochemical strategies for the possible enhancement of the efficiency of the EOD by DC power.

Further, the open circuit potentials observed by Rabie et al. (2) on the interruption of DC power are given an electrochemical interpretation which leads to quantitative estimates in agreement with the experimental values.     

钠化焙烧钒渣同时加碳氯化挥发镓的研究

考察了低温400℃和中温800℃条件下,添加活性碳及液体含碳物纸浆与钒渣、NaCl和Na_2CO_3混合焙烧时氯化挥发镓及钒转比为水溶性钒的情况。本实验得到的最高η_(Ga)为35.1％。焙烧料中不含Na_2CO_3和焙烧温度为400℃时,钒转比为水溶性钒的比率(ηv.t)较低。纸浆添加比L_(纸浆)为0.05mL/g、配料比W_(Na_2CO_3)/W_(Nacl)=2时,可望同时得到较高的η_(Ga)和(ηv.t)。     

Preparation and Properties of Sintering Additives Coated Si3N4 from Heterogeneous Nucleation Processing

The sintering additives such as Al2O3 and /or Y2O3 were coated on the surfaces of Si3N4 particles via heterogeneous nucleation processing using a buffered pH solution as the precipitation reagent .They nucleated and grew only on the surfaces of Si3N4 and did not form sol particles in solution by TEM observation .The isoelectric point(IEP) of coated Si3N4 was different from that of as-received Si3N4.The IEP of Al(OH)3-coated Si3N4 occurred at pH8.4, which is close to that of alumina .When Al(OH)3-coated Si3N4 particles were coated with Y(OH)3,the IEP of coated Si3N4 powder shifted from pH8.4 to pH9.2 ,similar to that of yttria.In addition ,the rheological data showed that Al2O3 and /or Y2O3 coated Si3N4 suspension is nearly Newtonian and that added Si3N4 suspension shows a shear rate thinning behavior.     

电工实践教学改革与实践

电工实践教学是培养大学生电类工程能力的重要环节，本文介绍我们以培养人才为中心在电工实习基地建设；实践教学内容，方法和手段等方面进行的改革与实践。     

Disparity field and depth map coding for multiview 3D image generation

In the present paper techniques are examined for the coding of the depth map and disparity fields for stereo or multiview image communication applications. It is assumed that both the left and right channels of the multiview image sequence are coded using block- or object-based methods. A dynamic programming algorithm is used to estimate a disparity field between each stereo image pair. Depth is then estimated and occlusions are optionally detected, based on the estimated disparity fields. Spatial interpolation techniques are examined based on the disparity/depth information and the detection of occluded regions using either stereoscopic or trinocular camera configurations. It is seen that the presence of a third camera at the transmitter site improves the estimation of disparities, the detection of occlusions and the accuracy of the resulting spatial interpolation at the receiver. Various disparity field and depth map coding techniques are then proposed and evaluated, with emphasis given to the quality of the resulting intermediate images at the receiver site. Block-based and wireframe modeling techniques are examined for the coding of isolated depth or disparity map information. Further, 2D and 3D motion compensation techniques are evaluated for the coding of sequences of depth or disparity maps. The motion fields needed may be available as a byproduct of block-based or object-based coding of the intensity images. Experimental results are given for the evaluation of the performance of the proposed coding and spatial interpolation methods.     

鼓风引射式燃气燃烧器的计算

提出鼓风式射式燃气燃烧器的基本计算公式与计算结果，并进行结构尺寸与工况分析，确定各种因素对其的影响程度。     

快速星图匹配算法的研究

将态敏感和姿态稳定是卫星的重要技术之一。星体敏感器是目前最高精度的姿态测量技术。对于这种技术，很多文献都进行了讨论，并涌现了许多关于星图匹配行之有效的算法。